Antique Rusty Pruning Saw - Too Broken to Restore... I Make a New One (2160p_25fps_AV1-128kbit_AAC)

This old rusty and broken pruning rip saw was sent to me by a follower on Instagram. He was on a mission to clean the Swiss Alps from trash. They removed around two tons of trash in total. At the Albert-Heim-Hut, which was built in 1918, he found this old pruning saw. It must have been digged into the ground for decades. It was in a terrible condition to say the least. The handle was missing half of it and the wood was rotten. The blade looked very bad, it had very thick layers of rust and dirt on it. Right when I saw this saw for the first time on a picture I knew this will be a very difficult project. It was very obvious that I need to replace the handle, the question was if I could possibly save the blade. Because otherwise there would be nothing left from the original saw after the restoration. After sandblasting it was very clear right away that the damage on the blade is beyond repair. Rust has eaten away a lot of material, some teeth were missing and there was heavy pitting all over the blade. I thought for a few days what I want to do with this project. Should I trash it and start something new, or should I keep going and replace what needs to be replaced, even though there would only two brass plates stay from the original saw. I also asked this question to my Patreon and channel members and the answer was a very clear „yes, keep going“. And that&what I did. For the blade I choose a stainless high carbon steel (1.4116). As the original teeth had no offset, it was...