OpenWRT - x86 PC Installation - Live USB

In this video, we are going to install OpenWRT on x86 hardware, aka PC, server or laptop. This will give you the best performance thanks to the powerful hardware the x86 (Intel/AMD) architecture offer. The steps is simple: create a live USB, connect all the cables and powering on the PC (with USB plugged in, of course) It had been explained in the video about the images format, just to summary: - combined-ext4 image - the partion can be resized to a larger one, but factory reset & fail safe mode is not supported. - combined-squashfs - the partion is only 230 MB, resize is impossible. Factory reset and fail safe mode is supported. Video timeframe: 00:00 - Introduction about OpenWRT on x86, build targets and images format 02:30 - Network interface cards supported by OpenWRT (with default build) 03:15 - Creating OpenWRT live USB with Rufus 04:13 - Install and boot up the PC with OpenWRT 05:02 - Basic OpenWRT setup on x86 PC 07:20 - Test and troubleshooting 08:08 - Disable IPv6 on OpenWRT on CLI 10:01 - Change OpenWRT LAN IP on CLI 11:30 - Final words Useful links: Check out other OpenWRT tutorials on my channel. If there is anything not clear or there is any question, feel free to leave it in the comment section and we can discuss. As always, please like, share and subscribe to the channel to support me. Thank you!