How to Install an ET2 Fixture that is Stem Hung

Аватар автора
Интерьерные Идеи: Креативные Решения
Many of our pendants are stem hung and would follow these instructions. We will demonstrate the installation using our Rubric Pendant. First remove the mounting bracket from the canopy Then pull out the Driver, and you will notice the pendant’s low voltage wires connected to a terminal block which is linked to the driver. Disconnect the pendant wires from the terminal box and pull the wires through the canopy. At this point you can add stems by guiding the wires through the opening. Now you will want to re-connect the low-voltage wires to the terminal block. Take the red low voltage wire and match it to the red wire of the terminal box doing the same thing with the black to black, like so. MAKE SURE TO HOLD WIRES TIGHT WHEN TWISTING RODS TOGETHER. you can short the wires if you twist them.

0/0


0/0

0/0

0/0